Skip to content
Formulaxis
Sourced data · selected extract

Bosch Rexroth CDL1: bores, rods, areas and forces

Selected extract from the 2009 Rexroth CDL1 catalogue with ideal forces at 160 bar, conversions and usage limits.

Formulaxis · Documented technical demonstration · Revision: 15 November 2026

What is this table for? Selected extract from the 2009 Rexroth CDL1 catalogue with ideal forces at 160 bar, conversions and usage limits.

A cylinder table, not a sizing certificate

The Bosch Rexroth document RE 17325/07.09 gives theoretical areas and forces for the CDL1 series by piston/rod diameter pairs. It is a historical catalogue : current configurations and manufacturing limits must be confirmed with the manufacturer. The extension forces below correspond to the document's theoretical 160 bar case, without our η = 0.90 coefficient.

CDL1: effective areas and ideal forces

Piston / rodCap-end A (cm²)Annular A (cm²)Extension F at 160 bar (kN)Retraction F at 160 bar (kN)
CDL1 Ø 50 / rod 2819.6313.4731.4021.55
CDL1 Ø 63 / rod 3631.1620.9849.8533.57
CDL1 Ø 80 / rod 4550.2434.3480.3854.95

Selection from Bosch Rexroth RE 17325/07.09, p. 3, “Area, force, flow”.

Hand check

1 bar × 1 cm² = 10 N; Ø63 extension F ≈ 160 × 31.16 × 10 = 49 856 N ≈ 49.85 kN.

In a real 100 bar case, the same diameter gives about 31.16 kN ideally, before losses and back pressure. Do not copy the 160 bar force without checking the pressure actually available at the cylinder.

Rod diameter does not guarantee buckling resistance. Effective length, material grade, mountings, guidance and load position must be studied alongside the force table.

Return to the practical example

Values are useful only when assumptions, dimensions, axes and reference conditions are consistent with the calculation. Guide: cylinder force, stroke and buckling

Sources and data status

Numerical values are retained in this document even if URLs change. The tables are reconstructed selections with source attribution, not full copies of brochures. Formulaxis calculations and teaching assumptions are identified separately.

  1. Bosch Rexroth — CDL1, technical data sheet RE 17325/07.09Table p. 3: piston/rod and areas; p. 19: buckling criteria; historical catalogue, confirm before ordering today.

Sources consulted / results cross-checked on 15 November 2026. Data sheets and catalogues may be revised: check the current edition for a real project.