Skip to content
Formulaxis
Sourced data · selected extract

IPE 160 to 220: mass, second moment of area and elastic section modulus

Four useful ArcelorMittal catalogue rows, strong y-y axis: figures retained with sources, units and bending applications.

Formulaxis · Documented technical demonstration · Revision: 15 November 2026

What is this table for? Four useful ArcelorMittal catalogue rows, strong y-y axis: figures retained with sources, units and bending applications.

Why check the catalogue axis?

IPE sections have a strong axis and a weak axis. The selection table below uses the strong y-y axis from ArcelorMittal's Orange Book for standard IPE sections (not IPE A/AA/O). Mass is per metre of section, and I/W are geometric properties, not allowable stresses.

Original figures and the manufacturer's full table remain accessible through the source; the four useful rows are retained on this page.

IPE 160, 180, 200, 220 — strong-axis values

Standard sectionMass kg/mIy (cm⁴)Wel,y (cm³)
IPE 16015.8869109
IPE 18018.81 320146
IPE 20022.41 940194
IPE 22026.22 770252

ArcelorMittal Orange Book, IPE section properties. Selected rounded values reproduced as shown in the catalogue.

Conversions that prevent factor-of-10 000 errors

1 cm⁴ = 10 000 mm⁴ ; 1 cm³ = 1 000 mm³ ; σ(MPa) = M(N·mm) / W(mm³)

Example: IPE 200, W = 194 cm³ = 194 000 mm³; at 12 kN·m, σ = 12 000 000 / 194 000 = 61.86 MPa. For deflection, use I = 1 940 cm⁴ = 19 400 000 mm⁴. Geometry from a simplified sharp-cornered section may differ from catalogue values because it ignores radii and actual dimensions.

Do not confuse section properties with a code check: material, lateral buckling, shear, joints, loads and combinations still require substantiation.

Return to the practical example

Values are useful only when assumptions, dimensions, axes and reference conditions are consistent with the calculation. Guide: check a beam

Sources and data status

Numerical values are retained in this document even if URLs change. The tables are reconstructed selections with source attribution, not full copies of brochures. Formulaxis calculations and teaching assumptions are identified separately.

  1. ArcelorMittal — Orange Book, IPE propertiesIPE I, W, mass and axes; geometry source.

Sources consulted / results cross-checked on 15 November 2026. Data sheets and catalogues may be revised: check the current edition for a real project.