Skip to content
Formulaxis
Sourced data · selected extract

M8–M12 tapping: actual drills and the D − P rule

Extract from a Dormer Pramet cutting-tap data sheet with fine and coarse pitches, manufacturer values and D−P estimates.

Formulaxis · Documented technical demonstration · Revision: 15 November 2026

What is this table for? Extract from a Dormer Pramet cutting-tap data sheet with fine and coarse pitches, manufacturer values and D−P estimates.

Which tap family do these values apply to?

The diameters below come from Dormer Pramet Platinum Cut Taps : this range consists of cutting taps. It does not describe forming tools, thread inserts or all materials. The D−P column is an independent Formulaxis calculation alongside the range recommendation to explain rounding differences.

Useful sizes: coarse and fine pitches

ISO metric threadTheoretical D − P (mm)Range drill (mm)Process
M8 × 1.256.756.80cutting
M10 × 1.258.758.80cutting
M10 × 1.508.508.50cutting
M12 × 1.7510.2510.30cutting
M12 × 1.5010.5010.50cutting
M12 × 1.2510.7510.80cutting

Selected reconstruction of the Dormer Pramet table, page 1; cross-check product designation before manufacturing.

What the table does not tell you

It does not provide minimum blind-hole depth, cutting speed for your material, actual thread engagement percentage or a thread inspection plan. These depend on tap chamfer length, material grade, cutting conditions and drawing tolerance.

Do not use these values for a forming tap. Find the tap-drill diameter in the exact tool's catalogue.

Return to the practical example

Values are useful only when assumptions, dimensions, axes and reference conditions are consistent with the calculation. Guide: choose your drill and feed

Sources and data status

Numerical values are retained in this document even if URLs change. The tables are reconstructed selections with source attribution, not full copies of brochures. Formulaxis calculations and teaching assumptions are identified separately.

  1. Dormer Pramet — Platinum cut taps, p. 1M8 / M10 / M12 rows, coarse and fine pitches; cutting-tap drills.
  2. Dormer Pramet — choosing tap-drill diameterCutting / forming distinction, hole inspection and adjustments for tool and material.

Sources consulted / results cross-checked on 15 November 2026. Data sheets and catalogues may be revised: check the current edition for a real project.