Skip to content
Formulaxis
Sourced data · selected extract

SKF 6206-RZ: input data sheet for C, C₀ and dimensions

Published dimensions and ratings for an identifiable bearing, distinguishing manufacturer values from operating loads.

Formulaxis · Documented technical demonstration · Revision: 15 November 2026

What is this table for? Published dimensions and ratings for an identifiable bearing, distinguishing manufacturer values from operating loads.

What C and C₀ mean

C is the basic dynamic load rating used in basic rating life calculations. C₀ is a static rating used to check contact deformation. They are not the applied load P and equivalent static load P₀ respectively. Those come from machine forces and, where needed, catalogue factors.

SKF extract: 6206-RZ bearing

Referenced (mm)D (mm)B (mm)C (kN)C₀ (kN)
SKF 6206-RZ30621620.311.2

Source: official SKF 6206-RZ product page; for another 6206 variant, check seal, clearance, rating and speed on the correct data sheet.

How to copy the units

C = 20.3 kN; C₀ = 11.2 kN; for Fr = 4 kN and Fa = 0, P = P₀ = 4 kN (in the radial example).

At 1 200 rpm, this gives L10 = (20.3/4)³ ≈ 130.71 million revolutions, or about 1 815 h. This is basic rating life, not the actual maintenance replacement interval.

Avoid transferring these ratings to another manufacturer or variant merely because dimensions match.

Return to the practical example

Values are useful only when assumptions, dimensions, axes and reference conditions are consistent with the calculation. Guide: select and check a bearing

Sources and data status

Numerical values are retained in this document even if URLs change. The tables are reconstructed selections with source attribution, not full copies of brochures. Formulaxis calculations and teaching assumptions are identified separately.

  1. SKF — 6206-RZ product data sheet30 × 62 × 16 mm ; C = 20.3 kN ; C₀ = 11.2 kN.
  2. SKF — bearing selection processSelection criteria beyond L10 life.

Sources consulted / results cross-checked on 15 November 2026. Data sheets and catalogues may be revised: check the current edition for a real project.